Table of Contents
Advertisement
Attach the exhaust tips and locate them so that they are below the tail lights. Move the rubber hanger if
necessary.
Adjust the exhaust so that it does not hit/sit any frame member or the back of the body.
Use the tube bend over the axle as a lever to rotate the front tube to level the tips out.
Raise or lower the rubber hanger as needed or push the rear tube onto the front tube more or less to
get the correct height.
Rotate the rear tube to change the angle of the tip slightly or straighten the tip when looked down
on from above.
Tighten the front tube to muffler clamp nuts using a
" wrench.
/
9
16
301
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
