Table of Contents
Advertisement
Caution
Only the personnel that installed the Cisco telepresence and the customer's network
administrator should modify the Cisco telepresence configuration.
Procedure
Step 1
Step 2
Step 3
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Make sure the SCOPIA Management IP address and port number are configured in the SIP
trunk.
a.
Select the relevant trunk in the Device > Trunk tab.
b.
In the Trunk Configuration page, make sure that the SCOPIA Management IP address is
configured in the Destination Address field.
Figure 5-1
c.
Verify the port number for SIP services is configured in the Destination Port field. By
default the field is set to 5060.
Make sure the SIP trunk is configured to strip the external access code dialed by the CUCM.
This enables the SCOPIA Management to receive the expected number of digits for a SCOPIA
Elite MCU conference.
a.
Select the relevant route pattern in the Call Routing > Route/Hunt > Route Pattern tab.
b.
In the Route Pattern Configuration page verify that the Discard Digits field is configured
to PreDot.
Figure 5-2
Make sure the bandwidth is configured to more than 1Mbps, which is the value required for
telepresence. A value under 1Mbps causes the videoconference to disconnect.
a.
Select the relevant server and service in the System > Service Parameters tab.
b.
In the Service Parameter Configuration page make sure that the Default Intraregion
Max Video Call Bit Rate (includes Audio) field is configured to 8128 kbps.
Figure 5-3
The Clusterwide Parameters section (System - Location and
Region)
The SIP Information section
The Called Party Transformations section
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 24
Advertisement
Table of Contents
