Table of Contents
Advertisement
Note
This section details how to encrypt communications between the SCOPIA Gateway and the
video network.
To encrypt control and management communications between SCOPIA Management and the
SIP and H.323 networks, see
65
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Encrypting communications between the gateway and SCOPIA Management is
typically less common since they are usually both located behind the firewall inside
an enterprise.
Access the SCOPIA Management administrator portal.
Select Devices > Devices by Type > Gateways.
Select the gateway you require.
Select the Configure tab.
For encrypting communications between the gateway and the SIP network , select one of
these settings for the Service Encryption field:
Table 6-1
Configuring the encryption
Field Name
Best effort
Mandatory
For encrypting communications between the gateway and the H.323 network, especially the
MCU, proceed as follows:
a.
Select Advanced Parameter Settings.
The Advanced Parameters dialog box appears (see
b.
Type h235callssupport in the Command ID field.
c.
Clean the Value field.
d.
Select Get.
SCOPIA Management automatically sets the port's value to 1 in the Value field.
"Enabling the TLS Connection in SCOPIA Management" on page
Description
When selected, indicates the gateway
supports encryption. If the remote site does
not support it, communications are not
encrypted.
Communications are always encrypted. If the
remote site does not support encryption,
communications fail.
Figure 6-18 on page
65).
Securing Your Video Network Using TLS | 64
Advertisement
Table of Contents
