Table of Contents
Advertisement
Step 2
Step 3
Retrieving CTMS Routing Information for SCOPIA Management
Configure the CTMS route pattern prefix and service numbers in SCOPIA Management to route
calls to the Cisco telepresence devices. For more information, see
SCOPIA Management" on page
This procedure describes how to retrieve CTMS information from the relevant Cisco devices.
Note
This number is configured only by the personnel that installed the Cisco services or by the
customer's network administrator.
Procedure
Step 1
Step 2
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Select System Settings > Route Pattern.
Write down the CTMS Directory Number as you need it for configuring the CTMS prefix in
SCOPIA Management.
For more information, see
Figure 5-9
Retrieve the CTMS route pattern prefix.
a.
In the CUCM web interface select the relevant route pattern that was configured for the
CTMS in the Call Routing > Route/Hunt > Route Pattern tab.
b.
Write down the prefix used for routing the incoming calls on the CTMS trunk.
Figure 5-10
Retrieve the CTMS service numbers.
a.
In the the CTMS web interface select System Settings > Static Meetings.
"Adding the CTMS to SCOPIA Management" on page
Locating the CTMS Directory Number
34.
The CTMS Route Pattern prefix
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 37
34.
"Adding the CTMS to
Advertisement
Table of Contents
