Table of Contents
Advertisement
Configuring the SCOPIA TIP Gateway in SCOPIA Management
This section explains how to configure the settings in SCOPIA Management.
Since the SCOPIA Gateway does not have its own web interface, its configuration is performed
in SCOPIA Management.
SCOPIA Management and gateways communicate in XML over TCP for control and configuration
commands. You can secure the connection by configuring it to the TLS protocol. Make sure to
generate the SCOPIA Management and SCOPIA Gateway certificates before configuring the
connection to TLS (see
Before you begin
Procedure
Step 1
Step 2
Step 3
Step 4
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Field Name
Model
Registered To
"Securing Your Video Network Using TLS" on page
Access the SCOPIA Management administrator portal.
Select the Devices > Devices by Type > Gateways.
Select the SCOPIA Gateway you are configuring.
Select the Configure tab.
Description
This field is only necessary when adding gatekeepers and
gateways:
•
If adding a gatekeeper profile, select the gatekeeper's
vendor and model from the list.
•
If adding a gateway profile, select the gateway type from
the list.
Select the gatekeeper to which the telepresence system is
registered to from the list.
If you select None, the endpoint can be added to SCOPIA
Management but will not be connected until you register the
endpoint with the gatekeeper, and select the gatekeeper
here.
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 30
43).
Advertisement
Table of Contents
