Planning Your Tip Gateway Deployment; Planning Your Topology For The Tip Gateway - RADVision SCOPIA TIP Deployment Manual

2

Planning your TIP Gateway Deployment

Perform the procedures in this section to prepare the site and device for installation.

Planning your Topology for the TIP Gateway

Deploying the SCOPIA TIP Gateway requires configuring the unit itself as well as several other
components.
Depending on the deployment, the setup is composed of these mandatory components:
Other optional components typically include:
Figure 2-1 on page 5
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
•
Planning your Topology for the TIP Gateway ............................................ page 4
•
Creating Dial Plans for Cisco Telepresence ............................................... page 5
•
Ports to Open on the SCOPIA TIP Gateway ............................................... page 6
•
TIP Gateway
•
SCOPIA Management
•
SCOPIA Elite MCU for housing telepresence meetings with multiple endpoints, both H.323
and SIP.
•
H.323/SIP endpoints
•
CUCM (Cisco Unified Communications Manager). This is the central communication server
for all Cisco related products.
•
Cisco Telepresence Systems. These include single-presence CTS-500/1000 Series and
triple-presence CTS-3000 Series.
•
CTMS (Cisco Telepresence Multipoint Switch), which is the Cisco MCU
•
CTS-Manager, Cisco's application for scheduling meetings.
describes a typical deployment of the TIP Gateway.
Planning your TIP Gateway Deployment | 4