Table of Contents
Advertisement
Step 5
Step 6
Step 7
Step 8
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Figure 5-12
Configure your telepresence endpoint as described in this table.
Table 5-5
Configuring telepresence endpoints
Field Name
Name
Description
Triple
Protocol
URI
Location
Visible in the directory
of other endpoints
Select OK.
Once configured, the Endpoints tab displays a small icon
indicating that the endpoint is a telepresence system as well as dialing info numbers with
relevant prefixes.
Repeat the above steps for each CTS in the deployment.
You can modify these settings at any time by selecting the device name link in the All
endpoints list.
Cisco CTS Configuration screen
Description
Enter a name used to identify the endpoint. This is the name
displayed in the list of endpoints.
Enter any description text that you may have for this endpoint.
Select this field if you are adding a 3-segment CTS-3000 Series
endpoint to the deployment.
For Cisco telepresence, this field is pre-configured to IP (SIP)
since the CTS endpoints are using the SIP protocol.
Enter the CTS phone number that is dialed when calling the
Telepresence System from the SCOPIA Elite MCU.
Select the location of the telepresence system, from the list.
Select to display the telepresence system in the corporate
address book.
The telepresence endpoint is represented in the address book as a
single endpoint.
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 39
near the endpoint name,
Advertisement
Table of Contents
