Verifying Rack Suitability; Choosing The Type Of Rack; Making Space For The Scopia Tip Gateway - RADVision SCOPIA TIP Deployment Manual

Hide thumbs Also See for SCOPIA TIP:

Table of Contents

Note

Before proceeding with the installation, verify that all of the ordered parts are present and in

good condition. Keep a record of the parts and serial numbers. If any parts are missing or

damaged, contact your sales representative.

Verifying Rack Suitability

There are some critical requirements that you must meet when choosing a rack and before

mounting the device into it.

There are many types of racks on the market. The installation instructions in this guide are

intended for a 19" rack.

When checking for an empty space to setup the device, be aware of its physical dimensions.

RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0

•

Choosing the Type of Rack ................................................................ page 10

•

Making Space for the SCOPIA TIP Gateway .............................................. page 10

•

Verify that the 19" rack meets the EIA-310 standards. This standard includes precise

definitions of the shape of the holes, their size, the depth of the rack and other features.

For more information on the EIA-310 standard, see

http://electronics.ihs.com/collections/eia/index.htm

•

Notice that the vertical square holes on the rack posts are not spaced equally. They form

a repeating pattern of two holes close together, then one hole separate, then two holes

close together and so on. See

Figure 3-2

•

Install the device in an open rack whenever possible. If installation in an enclosed rack is

unavoidable, ensure that the rack has adequate ventilation.

Figure 3-2 on page

10.

Hole distribution on 19" rack

Preparing the SCOPIA TIP Gateway Setup | 10

Table of Contents