Chapter 6: Configuring Ports And Port Groups; Port Manager - Raritan Command Center CC-SG Administrator's Manual

C 6: C P
HAPTER ONFIGURING ORTS AND

Chapter 6: Configuring Ports and Port Groups

This chapter discusses how to configure and edit ports and port groups. Procedures on how to use
ports (connect, disconnect, bookmark ports, search for ports, create views, use port power
management, use port chat) are described in Raritan's CommandCenter Secure Gateway User
Guide.

Port Manager

Port Manager commands allow you to configure, connect to, and disconnect from ports of serial
devices, generic devices, IPMI servers, and KVM devices in your CC-SG.
Once configured, CC-SG provides centralized access to the target devices(s) attached to
Dominion and IP-Reach units. CC-SG supports Raritan products, as listed in the table below.
*Requires DKX firmware support
P G
ORT ROUPS
R U N
ARITAN NITS UMBER OF
Dominion SX4 4
Dominion SX8 8
Dominion SX16 16
Dominion SX32 32
Dominion SX48 48
Dominion KSX440 8
Dominion KSX880 16
Dominion KX116* 16
Dominion KX216* 16
Dominion KX232* 32
Dominion KX416 16
Dominion KX432 32
Dominion KX101 1
IP-Reach Model Dependent
P2-SC Varies
P SSL
ORTS
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
Always On
75