Configuring Paths And Port - Motorola MCS 2000 User Manual

Configuring Paths
and Port
IC
Function Key Descriptions
F6 - COM TEST
(Communications Test)
F8 - SAVE
From the MAIN MENU, press F9 and then F3 to access this screen.
MOTOROLA Radio Service Software
MCS Model:
MAIN:CONFIGURATION:PC
Archive Path:....
FLASH Software Path:..C:\MRSS\MCS\UPGRADE
Bootstrap Code Path & FileName:.C:\MRSS\MCS\UPGRADE\MCSBOOT.ENC
SRIB Software Path & FileName:..C:\MRSS\MCS\SRIB\SMARTRIB.ENC
System Key:......
Speed Optimization........Enabled
Memory Optimization......Disabled
TCMS Path:.......
RIB...........COM 1
F1 F2 F3 F4
HELP
This screen is used to set default disk drive paths for archive and back-
up files. It is also used to select the asynchronous communications
port (COM 1, COM 2, COM 3 or COM 4) to which the RIB (radio
interface box) will be connected.
Note: Refer to the owner's manual that came with your
computer for a complete description of directory path names
and asynchronous communications ports.
Verifies if the computer is set up correctly and is able to read and
program the radio codeplug properly. After your computer and RIB are
connected according to instructions on page 4 and you have selected
the appropriate communication port, turn on your radio and perform
a COM TEST by pressing F6.
COM TEST will verify if your system is functioning properly by
sending commands to the radio and checking for the proper response.
An OK response will be displayed in the Status Window if the system
checks okay. Otherwise, error messages will be displayed. Make sure
that all cables and power supplies are connected according to
instructions provided in this manual.
Note: No codeplug changes will result from these commands.
Used to save configuration information to a file on your program disk.
Every time you use the RSS, the configuration that you saved last will
be used. The configuration file will be named MCS.CFG. This
configuration may be altered and saved at any time.
Enter Path.
CONFIGURE PATHS AND PORT
------------------------
F5 F6 F7
COM
TEST
F8 F9 F10
SAVE EXIT
23