Motorola MCS 2000 User Manual page 255

Radio ID
PTT-ID Type
PTT-ID Sidetone
Pretime Duration (ms)
Baud Rate
DOS
Unmute Hold-Off (ms)
Use the UP/DOWN arrow keys to scroll or directly enter the Radio ID.
This field specifies the ID of the radio in decimals. For normal
addressing mode, valid radio IDs range from 0 (zero) to 2047. For the
extended addressing mode, valid radio IDs range from 0 (zero) to 9999.
This ID is used for both PTT-ID and Emergency Alarm data
transmissions.
The default is 0000.
Use the UP/DOWN arrow keys to make a selection. The value in this
field specifies the placement of the PTT-ID data in a GE STAR
transmission. The PTT-ID Data can be sent using one of the following
methods:
Immediately after a PTT press and before voice (Leading);
Immediately after a PTT release and after voice (Trailing); or
Both immediately after a PTT press and PTT release (Lead/Trail).
The default is Disabled.
This field will be visible only if the PTT-ID Type field is set to a value other
than Disabled. Use the UP/DOWN arrow keys to enable/disable this
feature. This field specifies whether or not the radio generates a
sidetone when sending leading GE STAR PTT-ID data.
The default is Enabled.
Use the UP/DOWN arrow keys to scroll or directly enter the desired
duration. This field specifies the duration of the pre-time transmission
preceding the PTT-ID and Emergency GE STAR data. The range is 0
(zero) to 2000 ms in 25-ms increments.
The default is 500.
Use the UP/DOWN arrow keys to select 400 bps or 800 bps. This field
specifies the baud rate of the GE STAR data in bits per second.
The default is 400 bps.
Use the UP/DOWN arrow keys to enable/disable the Data Operated
Squelch (DOS) feature for this system.
The default is Enabled.
This field will be visible only if the DOS field is set to Enabled. Use the UP/
DOWN arrow keys to scroll through the available choices or enter the
desired time directly. The range is 25 through 2550 in 25-ms
increments. This field specifies the duration that the radio waits with
speaker muted for a DOS detect after a carrier is first detected.
The default is 550.
249