Motorola MCS 2000 User Manual page 132

Priority 1 Member
Priority 2 Member
Non-Priority Members
Fixed
OP/SEL
(Operator
Selectable)
Designated Tx Mem
Selected Chan
Talkback
Zn
Chn
126
This field is visible only when the Priority 1 Type field is set to Fixed or OP/
SEL. Use the UP/DOWN arrow keys to select the Scan member which
has First Priority in scan selection. The channel number may also be
entered directly. When assigned, the Priority 1 Member is typically
Member 1 in the Scan List. Select None for no First Priority channel.
The default is None.
This field is visible only when the Priority 2 Type field is set to Fixed or OP/
SEL. Use the UP/DOWN arrow keys to select the Scan Member which
has Second Priority in scan selection. Select None for no Second
Priority channel.
Note: The member selections for Priority 1 Member and Priority
2 Member must be different.
The default is None.
Use the UP/DOWN arrow keys to select the non-priority scan type
from among the following:
The radio uses a selected member of the scan list configured from the RSS as
the Priority Channel. This member is fixed and cannot be programmed from the
radio.
The radio uses a selected member of the scan list as the Priority Channel. The
user must select the member of the scan list to be used as the priority member.
This member can be programmed both from the RSS and the radio.
The default is Fixed.
Use the UP/DOWN arrow keys to select the Designated Transmit
Talkback channel. For Conventional scan lists, this may be the number
of the scan member which will serve as designated transmit channel
during scan operation. Enter the number of the scan member to have
a fixed channel. This channel may not be a receive-only channel. The
other options are:
Transmission will occur on the last user-selected channel.
Transmission will occur on the same channel that the scanner stopped on.
Note: If the channel is a receive-only channel, the radio will
issue a warning to inform you that transmission is not possible.
The default is Talkback.
Use the UP/DOWN arrow keys to select the Zone (or System) for this
member of the scan list. The Zone (System) name from the ZONE/
CHANNEL ASSIGNMENT screen (F4/F8) will be shown to the right.
Use the UP/DOWN arrow keys to select the Channel (or Subfleet) for
this member of the scan list. The Zone (System) name from the ZONE/
CHANNEL ASSIGNMENT screen (F4/F8) will be shown to the right.