Motorola MCS 2000 User Manual page 233

Trailing PTT-ID
Radio Check
Radio Inhibit
Status
Status Request
Message
Use the UP/DOWN arrow keys to enable/disable the MDC unit
identification data packet transmission at the end of each transmission
(EOT). If the trailing PTT-ID feature is enabled and the microphone
PTT is released, the radio will automatically send the radio's unit
identification code to the dispatcher.The PTT-ID Sidetone will NOT
sound for trailing PTT-IDs.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable this feature. Enabling
this option allows the dispatcher to check the state of the radio (that
is, turned on or off), as long as the radio is within range of the system
(clear mode).
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable this feature. The
Radio Inhibit feature allows the radio to respond to a remote Inhibit
signal which is essentially a shut-down command from the dispatcher.
Upon receipt of this command, the radio transmits a quick
acknowledgment to the dispatch equipment; it then goes into a
dormant state during which the receiver audio is muted and the
transmit audio path is blocked. In addition, all operator controls are
rendered inoperative, channel scan is stopped on the operating Mode
which received the command, and all LEDs are turned off. The radio
will remain in this Inhibited state until it receives an Enable
command. Alternatively, the radio may be uninhibited by reading and
re-writing its codeplug with the RSS.
The default is Disabled.
This field indicates whether or not the Status feature is enabled. The
Status feature, when enabled, allows the user to select and transmit a
specific status from a list pre-programmed into the radio. A complete
activation of the Status feature therefore includes first enabling the
feature and then programming the desired status list to be made
available to the user. Status list programming is performed from the
STATUS ALIAS screen (F4/F6/F9).
The default is Disabled.
This field will be visible only if the Status field is set to Enabled. Use the
UP/DOWN arrow keys to enable/disable this feature. If Status Request
is enabled, the radio responds to a remote status interrogation with the
last attempted status. Disabling the feature prohibits the radio from
responding to a remote status interrogation.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, the user can select and transmit a specific message
from a list pre-programmed into the radio. A complete activation of
the message feature therefore includes first enabling the feature and
then programming the desired list of messages to be made available to
the user. Message list programming is performed from the MESSAGE
ALIAS screen (F4/F6/F8).
The default is Disabled.
227