Clone Radio - Motorola MCS 2000 User Manual

Clone Radio

CE
Function Key Descriptions
F2 - READ SER NUM
(Read serial number)
F3 - CONV ID
(Conventional ID)
F4 - LIMITED CLONE
F6 - DUPLICATE II/IIi ID
F7 - SAVE FILE
F8 - PROGRAM RADIO
From the MAIN MENU, press F3 and then F5 to access the TRUNKED
CLONING screen.
MOTOROLA Radio Service Software
MCS Model:
MAIN:GET/SAVE/PROG:CLONE RADIO
Serial Number............
Pers # System Key Type
------ ---------- ----
01 Disabled
F1 F2 F3
HELP READ CONV LIMITED
SER NUM ID
The CLONE radio function is used to copy codeplug information from
one radio to another. Only radios with the same model number may be
cloned.
Allows you to read the serial number of the "target" radio.
Brings up a screen where you can assign MDC IDs. This function will be
active only when a Trunking-capable radio is being cloned.
Clones the Conventional and radio wide sections of the codeplug. This
deletes the Trunking data and reads the serial number from the radio.
In order to perform Limited Clone:
Trunking system keys (or an FTR Key) are required to clone Trunking
System data.
The target radio must be connected to the computer so that its serial
number can be determined.
Duplicates the selected Type II/IIi ID (the one under the cursor) into
all other Type II/IIi personalities for which system keys are present.
Creates or updates an archive copy of the codeplug information on a
disk or hard disk.
Note: An archive copy of every radio installed or serviced is
strongly recommended. You will then be able to quickly restore
customer information in case of a codeplug failure.
Programs the "target" radio using saved codeplug data.
Select Function F1 - F10.
NEW TRUNKING IDS
----------------
System Type I
# ID Flt/ATG Indv ID
------ ------- -------
II 01 0001 None
F4 F5 F6
DUPLICATE SAVE
CLONE II/IIi ID FILE
II/IIi
Indv ID
-------
0001
F7 F8 F9 F10
PROGRAM EXIT
RADIO
77