Using The Commdtm - Procentec ComBricks User Manual

Fig. 101 - Setting up the PCD server
Next, select this location again and click 'Setup'. Enter the correct IP address of the ComBricks Head Station,
and choose the port and network you wish to connect to. Depending on the password settings in the
ComBricks, you might also have to fill in a username and password. Then click 'Ok'.

14.3 Using the CommDTM

Start your FDT manager and create or load a project. Vendor-independent platform PACTware is used in the
example below. Refer to the manual of your FDT manager for details.
In the upper menu, choose 'Device – Add device' and click on 'PROCENTEC DP-V1 Master', as shown in Fig.
102.
ComBricks User Manual v6.4.0 | January 18| © PROCENTEC 145/219