Table of Contents
Advertisement
SWASH RING
This function limits the swash travel to a fixed
range in order to prevent damaging the swash
linkage by simultaneous operation of the ailerons
and elevators. It is very useful in 3D aerobatics
which use a large travel.
● Select [SWASH RING] in the Linkage
menu and access the setup screen
shown below by pushing the RTN
button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
● The operating range display area:
The vertical direction shows the
e l e v a t o r t r a v e l . T h e h o r i z o n t a l
direction shows the aileron travel.
Swash ring setting procedure
1. Activate the function:
Move the cursor to the [ACT] item and push
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the Push
dial.
*The display blinks.
Push the RTN button to activate the function
and return to the cursor mode.
2. Rate setting:
Move the cursor to the [RATE] item. Push the
RTN button to switch to the data input mode.
Set the rate by scrolling the Push dial.
Initial value: 100%.
Adjustment range: 50 to 200%.
*Adjust the rate to maximum swash tilt.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
Push the RTN button to end adjustment and
return to the cursor mode.
90
<Functions of Linkage Menu>
Limits the swash plate travel to within a fixed range. (Helicopter only)
● When the swash ring function is activated,
a circle is displayed in the operating
range display area and the rate input box
is displayed. Stick operation is limited to
the area of this circle.
<Push Dial>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● The marker shows the
stick position.
Advertisement
Table of Contents
