Function - FUTABA T12K Instruction Manual

FUNCTION

When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and control (sticks,
switches, and trim levers).
*You can also assign the same function to multiple servo
output channels such as assigning elevator function to CH2
and CH3.
Channel Replacement
When the channel is replaced in the Function
menu, replaced channel uses the setting data (ATV,
SUB-TRIM, REVERSE, F/S, and B-F/S, etc.).
Servo Output Channels
For T-FHSS Air mode, you can set 12 linear
channels and two digital channels. For S-FHSS
mode, you can set only 8 linear channels.
● Select [FUNCTION] in the Linkage menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Function change
1. Move the cursor to the function item of the
channel you want to change and push the
RTN button.
*The function selection screen is displayed.
2. Move the cursor to the function name you
want to set and push the RTN button.
*The function name blinks.
3. Push the RTN button to execute the change.
(When you want to cancel this operation,
push the S1 button.)
*Multiple channels can be assigned to one function.
Channel assignment of each function can be changed.
Motor Function
Type selected and choose to activate the Motor
function, a reverse setting screen is displayed.
*If YES is selected, the output is reversed. If NO is selected,
Operation control change
1. Move the cursor to the "CTRL" item of the
2. Move the cursor to the control you want to
*DG1/2 (digital channels)
These channels can function as switched channels. You can
freely change combinations between servo output channels
and input controls (sticks, switches, and trim levers).
If you have either a Glider or Airplane Model
the output is normal.
Warning
To p r e v e n t t h e m o t o r f r o m s t a r t i n g
unexpectedly, switch off the motor. We also
suggest removing the propeller from the
motor as an additional precaution.
● Trim operation mode
"COMB": Combination mode
"SEPAR": Separate mode
It sets up by T1-T4 SET of LINKAGE MENU.
<Push Dial>
(The display screen is an example. The
screen depends on the model type.)
channel you want to change and push the
RTN button.
*The control selection screen is displayed.
change, and push the RTN button.
*The same control can be assigned to multiple channels.
<Functions of Linkage Menu>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
81