Table of Contents
Advertisement
SUB-TRIM
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
● Select [SUB-TRIM] in the Linkage menu and access
the setup screen shown below by pushing the RTN
button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Sub-trim adjustment
1. Move the cursor to the channel you want to
adjust and push the RTN button to switch to
the data input mode.
2. Adjust the rate by scrolling the Push dial.
Initial value: 0
Adjustment range: -240~+240 (steps)
(When the RTN button is pushed for one second, sub-trim is
reset to the initial value.)
*Before sub-trim adjustment, it is very important to adjust the
linkages at the control surface so that you do not use sub-
trim, except for very minute adjustments.
3. Push the RTN button to end adjustment and
return to the cursor mode.
4. Repeat this procedure for each channel.
Setting of neutral position of each servo.
<Push Dial>
● To input data mode
● Data is entered
● To next page
(The display screen is an example. The
screen depends on the model type.)
<Functions of Linkage Menu>
Scrolling
● Moving cursor
● Adjusting value
83
Advertisement
Table of Contents
