Table of Contents
Advertisement
TIMER ST1/ST2
The Timer function may be set for any desired
time, i.e. engine run time, specified times for
competitions, etc. Two independent timers are
provided for your use. The timers are stored
independently with each model, meaning that
when you switch between model setups, the timer
associated with the new model is brought up
automatically.
The timers may be set to start and stop from
the motion of any switch or stick. You may set the
ON and OFF directions freely. Each timer has a
capacity of up to 59 minutes 59, seconds.
Each timer may be set for countdown (DOWN
mode) or count-up (UP mode) operation with a
target time of up to 99 hours 59 minutes (HOUR
mode).
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during
the last twenty seconds and two short beeps during
the last ten seconds before reaching the target,
● Select ST1 or ST2 at the home screen and
call the setup screen shown below by
pushing the RTN button.
● Select the function name
and return to the home
screen by pushing the
RTN button or pushing the
HOME/EXIT button.
RETURN
Timer setting
"Vibes" type
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
TYPE 4
then a long tone at the target time, and continue
counting while displaying a minus (-) sign. Count-
up timers also beep the last twenty and ten seconds,
beep the target time, and keep counting upwards
until shutdown.
A mode which sounds an alarm each minute of
the time remaining up to the timer alarm time can
be selected.
The HOUR mode is convenient for engine
maintenance and other long-term measurements.
* When the HOUR mode is set, "xx (hour): xx (minute)"
is displayed on the count time display. Seconds are not
displayed.
* When the HOUR mode is set, ":" blinks each second during
timer operation.
* When the HOUR mode is set, the alarm function is
inhibited.
<Push Dial>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
<Appendix>
187
Advertisement
Table of Contents
