System - FUTABA T12K Instruction Manual

SYSTEM

System Type selection
The T12K is for 2.4GHz only. The system can
be changed from among 2 choices: T-FHSS Air
(12CH+ON/OFF-2CH) and S-FHSS (8CH).
*If you change the System Type, other model data is not
reset.
*If a system type is changed in helicopter mode, the
transmitter will offer two selections:
[Yes] : Selection sets the channel order suitable for System
Type. (We recommend here. )
[No] : The present channel order is maintained.
*After any change, remember to test the model and should
fully check servo direction and a motion.
● Select [SYSTEM] in the Linkage menu and access
the setup screen shown below by pushing the
RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Battery fail-safe voltage setup (only T-FHSS Air )
The voltage which battery fail-safe activates,
can be set when you link. (3.5-8.4V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8v) = 3.8 v
• 2 cells LiFe (Normal: 6.6 v) = 6.0 ~ 6.2 v
• 2 cells LiPo (Normal: 7.4 v) = 7.2 ~ 7.4 v
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
Cases when linking is necessary:
・When using a receiver other than the initial setting.
・When the communication system was changed.
(T-FHSS Air ↔ S-FHSS)
・When a new model was created by model
selection.
Linking method
Telemetry function (T-FHSS Air mode only)
To use the telemetry function, set "Telemetry"
to "ACT".
80 <Functions of Linkage Menu>
System mode setting, Receiver link
Receiver linking
being affected by other transmitters) by the
transmitter it is linked to. When using a receiver
other than one purchased as a set, linking is
necessary.
model is added by model selection, and the time of
system type change.
P.42
The receiver will only be controlled (without
Moreover, a re-link is required when a new
● In the case of T-FHSS, the
ID of the linked receiver
is displayed.
<Push Dial>
System Type selection procedure
1. Move the cursor to the [T-FHSS] item and
push the RTN button to switch to the data
input mode.
2. Select the system type by scrolling the Push
dial.
[T-FHSS] or [S-FHSS]
3. Push the RTN button to end adjustment and
return to the cursor mode.
System T-FHSS Air
CH 12CH+ON/OFF 2CH
Telemetry Possible
R3006SB
Receiver
R3008SB
(2017,11)
R3001SB
*The surface system
receivers receiver
cannot be used.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
S-FHSS
8CH
Impossible
R2006GS
R2106GF
R2008SB
R2001SB