Telemetry:ext-Volt - FUTABA T12K Instruction Manual

TELEMETRY : EXT-VOLT
The EXT-VOLT screen will display the data from
the EXT-battery output from the R3008SB receiver.
In order to use this function, it is necessary to
connect external voltage connector of the R3008SB
receiver to a CA-RVIN-700 (FUTM5551) or
SBS-01V to the battery you desire to measure the
voltage of.
● Select [EXT-VOLT] in the TELEMETRY screen and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
● ↓The arrow will indicate that
an alarm will sound when
the voltage drops to below
the setting.
Alert set
1. Move the cursor to the ↓ALERT [INH] item and
push the RTN button to switch to the data
input mode.
2. Select the ACT mode by scrolling the Push
dial.
3. Push the RTN button. (To terminate the input
and return to the original state, push the S1
button.)
4. Move the cursor to the ↓THRESHOLD [4.0V]
item and push the RTN button to switch to
the data input mode.
5. Adjust the rate by scrolling the Push dial.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6. Push the RTN button. (To terminate the input
and return to the original state, push the S1
button.)
Displaying data from the EXT battery voltage port
*CA-RVIN-700 or SBS-01V must be installed in the aircraft.
You will be alerted by an alarm or vibration if
the voltage set by you is exceeded.
*It cannot be used in S-FHSS mode
● The maximum and the minimum when
powering ON are shown.
If the following types are selected, the transmitter will
vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
TYPE 4
● EXT battery voltage
<Push Dial>
● To input data mode
● Data is entered
● To next page
"Vibes" type
<Functions of Linkage Menu>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
105