Push Dial Operation - FUTABA T12K Instruction Manual

Push Dial Operation

Data input operation is performed using the Push dial.
Push Dial：
Dial Scroll
Right part Long Push
[SYS]
Upper part Long Push
[LNK]
Left part Long Push
[MDL]
Lower part Long Push
[S1]
Lower part Push
[S1]
Center part Long Push
[RTN]
Center part Push
[RTN]
Movement of cursor, value input or mode
selection:
Movement of the cursor on the menu screen
and movement of the cursor among items on a
setup screen can be controlled by scrolling your
finger to the left and right in the direction of the
arrow in the scrolling diagram above. You can
also go to the next page, if there is a next page.
This scrolling technique is also used for data
input, value input, mode selection, and similar
operations. Examples include: Value, ON, OFF,
INH, ACT, etc.
<Before Use>
26
Push the
outer dial
part
Push Dial
The cursor moves accordingly.
Increases or decreases values accordingly.
Jump to System Menu screen directly.
Jump to Linkage Menu screen directly.
Jump to Model Menu screen directly.
The cursor moves to the top of next page.
The cursor moves to the top of page.
Reset to the initialized value.
Change to the input data mode.
Changes to the moving cursor mode.
The data is entered.
RTN button:
a setup screen or to switch between cursor move
mode (reverse display) and data input mode (box
display).
when a confirmation message is displayed on the
screen, etc.
Upper part
Push
Center part
Push
Lower part
Push
Push：Less than 1 second
Long Push：1 second or more
To Home screen
Push the RTN button when you want to open
This button can also be used as the enter button