Table of Contents
Advertisement
Extra Voltage Connector
Use this connector when using a voltage
telemetry device to send the battery voltage (DC0
~ 70V) from the receiver to the transmitter.
You will need to purchase the optional External
Voltage input cable (CA-RVIN-700) FUTM5551.
You can then make a cable with an extra
connector to the External voltage connector.
Danger
Don't touch wiring.
* There is a danger of receiving an electric shock.
Don't short-circuit the battery terminals.
* A short circuit across the battery terminals may cause
abnormal heating, fire and burns.
Please double check your polarity ( ＋ and
－ ) when hooking up your connectors.
* If ＋ and － of wiring are mistaken, it will damage,
ignite and explode.
Don't connect to Extra Voltage before
turning on a receiver power supply.
R3008SB CH MODE
The R3008SB receiver is a very versatile
unit. It has 8 PWM outputs, S.BUS and S.BUS2
outputs. Additionally, the PWM outputs can
be changed from channels 1-8 to channels
8-12(DG1,DG2). If you only desire to use it as
a 7-channel receiver (without S.BUS), it can be
used without any setting changes.
Output
connector
1 ～ 8CH
1
2
3
4
5
6
7/B
8/SB
Red LED blink
<Before Use>
32
R3008SB CH Mode table
Mode A
Mode B
1 ～ 7CH
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
S.BUS
1 time
2 times
Default CH mode
How to change the R3008SB Channel mode
The R3008SB is capable of changing its channel
allocations as described in the table below.
1. Turn on the receiver. (At this moment, the
transmitter should be off.) The LED will blink
RED in about 3 seconds. Next, wait until it
becomes solid RED.
2. Press and hold the Mode Switch for more 5
seconds.
3. Release the button when the LED blinks
RED and GREEN simultaneously.
4. The receiver is now in the "Operation
CH Set" mode. At this moment, the LED
indicates current set status through flashing
a pattern that corresponds to the CH
mode.
*Cannot exit this CH setting mode before the operation
mode is fixed.
*See the table below for LED flash codes and "CH mode"
meanings.
*Default CH mode is "Mode B".
5. By pressing the Mode Switch, the operation
CH is switched sequentially as "Mode C"
"Mode D" "Mode E" "Mode A"....
6. Set your desired operation mode by
holding the Mode Switch button for more
than two seconds when you reach the
desired mode.
7. Release the button when the LED blinks
RED and GREEN simultaneously. Then, the
operation CH is fixed.
8. Confirm that the CH mode is changed, turn
off the receiver, and then turn it back on.
*The "Operation CH Set" mode cannot be exited while the
receiver is connecting with the transmitter.
Channel
Mode C
Mode D
9 ～ 10CH
9 ～ 10CH
9
9
10
10
11
11
12
12
DG1
DG1
DG2
DG2
－
－
－
S.BUS
3 times
4 times
Mode E
8 ～ 10CH
8
9
10
11
12
DG1
DG2
S.BUS
5 times
Advertisement
Table of Contents
