Table of Contents
Advertisement
SNAP ROLL
This function selects the switch and rate
adjustment of ailerons, elevators, and rudder when
a snap roll is performed.
● Four snap roll directions can be set. (Right/up,
right/down, left/up, left/down)
● Operation mode: When [Master] mode is selected,
the Snap Roll function is turned ON/OFF by the
master switch. It is possible to set the direction
switch to the direction in which you want to snap
roll. When [Single] mode is selected, the snap roll
in each direction can be executed by means of
independent switches and positions.
● A safety switch can be set to prevent the
accidental activation of the snap roll. For
example, the landing gear is lowered, even if
the switch is turned on accidentally the snap roll
would not be executed. The snap roll switch is
activated only when the safety switch is OFF.
● Select [SNAP ROLL] at the Model menu
and access the setup screen shown
below by pushing the RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
[Corresponding model type]: Airplane, general
(Example) Setting example for F3A
● Mode: [Master]
● Safety SW: [SG] (Safety measure)
● Master SW: [SH] (Main switch for executing
snap roll)
● Direction switches:
*The snap roll up side left and right and down side left and right
direction switches are selected here.
Right/Up: OFF [SD]
Right/Down: OFF [SD]
Left/Up: OFF [SA]
Left/Down: OFF [SA]
<Model Menu (Airplane/Glider/Multirotor Functions)>
<Push Dial>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
● Master/single mode
selection
● Direction switches
167
Advertisement
Table of Contents
