Elevator
Aileron
The interior of your transmitter should look like the figure above. Use a small Phillips screwdriver
to rotate the adjusting screw of each stick for the desired spring tension. Increase tension by twisting
Mode 2 transmitter with rear case removed.
clockwise, decrease tension by twisting counter clockwise. When you have found the desired stick
tension, reattach the rear cover, install the four screws, then reinstall the battery and cover.
+ screw is clockwise.
+ screw is counter-clockwise.
Stick tension maximum
Stick tension minimum
*The screw will touch the case.
*The screw will touch the case.
<Before Use>
24
Stick
Do not over-loosen
Do not over-loosen
the screw or the
the screw or the
screw will touch
screw will touch
the case.
the case.
Stick
You can also adjust
how quickly a stick
returns to neutral.
Rudder