Table of Contents
Advertisement
CAMBER MIX
This function adjusts the rate of camber
operation for the wing camber (ailerons, camber
flaps, brake flaps) in the negative and positive
directions. The aileron, flap, and elevator rates
can also be adjusted independently and attitude
changes caused by camber operation can be
corrected.
● Select [CAMBER MIX] at the Model
menu and access the setup screen
shown below by pushing the RTN
button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
●Condition delay
setting
●Aileron rate
adjustment
●Flap rate
adjustment
●Elevator rate
adjustment
148
<Model Menu (Airplane/Glider/Multirotor Functions)>
[Corresponding model type]: Airplane/glider, 2 ailerons or more
●Condition delay
cut switch
*Initial setting assigns camber operation to side lever LS.
● The up/down rates of the aileron, flap, and
elevator servos can be adjusted. When the mixing
direction is reversed by the linkage, adjustments
can be made by changing the mixing rate
polarity (+ or -).
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● A condition delay can be set. A cut switch which
can turn OFF the delay function can be set.
*The display screen is an example. The actual
screen depends on the model type.
<Push Dial>
(Glider: Currently selected
condition name)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
Advertisement
Table of Contents
