Receiver Nomenclature - FUTABA T12K Instruction Manual

Receiver Nomenclature

Before using the receiver, be sure to read the precautions
listed in the following pages.
Receiver R3008SB
Connector
"1 through 6": outputs for the channels 1
through 6
"7/B": outputs of 7 channels and power.
(7/B)
Y-harness
"8/SB": outputs of 8 channels or S.BUS port.
[S.BUS Servo S.BUS Gyro ]
*When using 8/SB as S.BUS, you have to set
CH MODE of the following page to mode B/D/E.
"S.BUS2": outputs of S.BUS2 port.
[S.BUS2 Servo S.BUS2 Gyro Telemetry Sensor ]
*When using 8 or more channels, use an S.BUS
function or use a second R3008SB and link both
to your transmitter.
Connector insertion
Firmly insert the connector in the direction
shown in the figure. Insert the S.BUS2 by turning
it 90 degrees.
*If connected in this way, the device will short-circuit. A
7CH servo
*Digital servos for conventional systems do not operate.
*Analog servos may cause abnormal heat, fires, and/or burns.
S.BUS2 connectors
Battery
LED Monitor
the receiver.
Mode Switch
included with your receiver.
Extra Voltage Connector
Danger
Receiver
Do not connect either a switch
or battery in this manner.
Danger
Don't connect in the manner shown in the
figure above.
short circuit may cause abnormal heating, fire, and/or burns.
Don't connect servo for conventional
system to S.BUS/S.BUS2 port.
Warning
Don't connect an S.BUS servo / gyro to
S.BUS2 connector.
This monitor is used to check the CH mode of
Use the small plastic screwdriver that was
Switch is also used for the CH mode selection.
＋
－
<Before Use> 31