FUTABA T12K Instruction Manual page 154

Setting method
●Activate the function
Move the cursor to the [ACT] item and push
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
Push dial.
*The display blinks.
Push the RTN button to activate the function
and return to the cursor mode. (ON is
displayed.)
When setting a switch, move the cursor to
the [SW] item and push the RTN button to call
the selection screen. Select the switch and
set its ON direction. (Always ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Rate adjustment
Move the cursor to the aileron, flap or
elevator rate item and push the RTN button
to switch to the data input mode. Adjust the
rate independently by scrolling the Push dial.
Initial value: 0%
Adjustment range: -200~+200% (Elevator:
-120~+120%)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
● Elevator compensation curve adjustment
●Fine tune
The fine
tune control
hardware
Operation Mode
When the fine tune control is set, it is
displayed.
Mode : LIN. / ATL+ / ATL- / SYM.
*When Flying wing type, it was made not to display
BUTTERFLY ELE. (There is no elevator rate setting .)
154 <Model Menu (Airplane/Glider/Multirotor Functions)>
Offset point
2- Intermediate point
1- End point
* The range where mixing does not work close to the neutral
position of the elevator stick can be adjusted. (Glider only)
*When offset is set, the curve is initialized.
●Reference point adjustment
Move the cursor to the [OFFSET] item and
hold the airbrake stick to the desired position.
Then, push the RTN button for one second to
set the butterfly operational reference point.
Initial value: 15% (upper side)
Adjustment range: 0~100%
●Servo speed setting
Move the cursor to the aileron, flap or
elevator speed item and push the RTN button
to switch to the data input mode.
Adjust the rate by scrolling the Push dial.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to activate the function
and return to the cursor mode.
The fine tune rate
Range ： -100 ～
+100%
Actual rate
Fine Tune Control
Output (Y) Position (X)
Fixed (0) Fixed (offset
position)
Settable Settable
Settable Fixed