Telemetry - FUTABA T12K Instruction Manual

TELEMETRY

This screen displays your choice of data from the
receiver.
Also warnings can be activated regarding
other data from your aircraft. For example, if the
receiver voltage drops, the user can be warned by
an alarm (and vibration).
● [TELEMETRY] can be called if the HOME/EXIT button
is pushed from a home screen.
● Select [TELEMETRY] in the Linkage menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
How to see telemetry data
1. Telemetry screen can be called if the HOME/
EXIT button is pushed from the home screen.
Or select [TELEMETRY] in the Linkage menu
and access the setup screen by pushing the
RTN button.
2. If each item is chosen and the RTN button is
pushed, an alarm setup can be performed
w i t h t h e m i n i m u m / m a x i m u m a f t e r a
transmitter is turned on.
*Receiver voltage can be checked immediately. An optional
sensor will need to be attached to S.BUS2 of a receiver if
you would like to see other information.
*No special setup is necessary if each sensor displayed
is left as in the default setup. Separate sensor ID
is also unnecessary. However, if two or more of
one kind of sensor is used, setup is required in the
"SENSOR" menu.
100 <Functions of Linkage Menu>
Displaying data from the receiver
● Push S1 button to advance to next page.
*It cannot be used in S-FHSS mode
● Receiver -> Transmitter. The
reception strength is shown.
<Push Dial>
Warning
Do not watch the transmitter screen during
flight.
*You may lose sight of the aircraft during flight and this is
extremely dangerous. Have an assistant on hand to check
the screen for you. A pilot should NEVER take his eyes
off his aircraft.
Scrolling
● Moving cursor
● Selecting mode
● To input data mode
● Data is entered
● To next page