Table of Contents
Advertisement
SBD-1 CH setting
CH setting of SBD-1 is available.
The SBD-1 (option) is a converter for using
conventional servos (other than S.BUS servo) with
the S.BUS system.
1. Connect the SBD-1 and the battery to S.I/F
port with 3 ways hub or Y harness.
2. Select S.BUS SERVO menu in SYSTEM menu.
3. Move to page 3/3.
4. Operate RECALL button. (RECALL is chosen.
⇒ RTN is pushed.
second.) SBD-1 setting screen is shown.
WRITE operation is writing
RECALL operation is reading
CH settings to SBD-1.
CH settings from SBD-1.
5. Set CH to each port of SBD-1. (SX1, SX2 and
SX3)
* Setting range : CH1 ～ CH12，DG1，DG2
6. Operate WRITE button. (WRITE is chosen. ⇒
RTN is pushed. ⇒ RTN is pushed for 1 second.)
7. The settings are changed.
8. When the WRITE operation is successful, the
message "COMPLETED" is shown.
9. When the WRITE operation fails, the message
"FAILED" is shown.
70
<Functions of System Menu>
⇒ RTN is pushed for 1
Advertisement
Table of Contents
