FUTABA T12K Instruction Manual page 57

● Select [TRAINER] in the System menu and enter
the setup screen shown below by pushing the RTN
button.
● Select the function name
and return to the System
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Mode and switch selection
1. Access the setup screen page 4 shown
below by pushing the S1 button three times.
2. Move the cursor to the [ACT] or [16/12/8CH]
item and push the RTN button to switch to
the data input mode.
3. Select the mode by scrolling the Push dial.
The display blinks. Push the RTN button to
change the mode. (To terminate the mode
change, push the S1 button.)
"ACT": Enable operation by changing to [OFF]
or [ON].
"16/12/8 CH": When the student uses the
T12K,T14SG,T16SZ,T18SZ,T18MZ, select [16CH].
When the student uses the T14MZ, T12Z, T12FG
or FX-40, select [12CH]. Otherwise select
[8CH].
If changing the trainer switch:
4. Move the cursor to the [SW] item and push
the RTN button to access the switch setup
screen.
(See "Switch selection method" at the end of
this manual for selection method details.)
"SW": Select the desired switch.
Initial setting: SH
*The switch mode can also be selected when setting the ON
position on the switch setup screen. When [ALTERNATE
OFF] is selected, normal ON/OFF operation is performed.
When [ALTERNATE ON] is selected, the trainer function
<Push Dial>
is alternately turned on and off each time the switch is
operated. This allows alternate ON/OFF switching even
when a momentary switch (SH) is used.
Note: The trainer function won't be turned
on unless the Instructor transmitter receives
signals from the student transmitter. Be
sure to confirm this after connecting your
trainer cable.
Operating mode selection
(Setup screen page 1-3)
1. Move the cursor to the [MODE] item of the
channel you want to change and push the
RTN button to switch to the data input mode.
2. Select the mode by scrolling the Push dial.
The display blinks. Push the RTN button to
change the mode. (To terminate the mode
change, push the S1 button.)
"MODE": Select the desired operation mode
for each channel.
NORM: The model is controlled by signals from the student
transmitter.
MIX mode: The model is controlled by signals from the
instructor and student transmitters. (Reset the student's
model data to the default condition.)
FUNC mode (function mode): The model is controlled by
signals from the student transmitter with the instructor 's
setting. (Reset the student's model data to the default
condition.)
OFF: Only the instructor side operates.
<Functions of System Menu>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
57