FUTABA T12K Instruction Manual page 165

Setting method
● Activate the motor speed function
When using motor speed function, move the
cursor to the [INH] item and push the RTN
button to switch to the data input mode.
Select the [ACT] by scrolling the Push dial
and push the RTN button.
● Sifting the boundary between the 2 ranges
Move the cursor to the [SPEED1>2] item and
push the RTN button to switch to the data
input mode.
Adjust the boundary position by scrolling the
Push dial.
Initial value: 0%
Adjustment range: -100~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to return to the cursor
mode.
● Operation speed adjustment
Move the cursor to the [IN] (on to off) or [OUT]
(off to on) item and push the RTN button to
switch to the data input mode.
Adjust the operation speed you want to set
by scrolling the Push dial.
Initial value: 0
Adjustment range: 0~27
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to return to the cursor
mode.
● Set/Reset the one time operation
Move the cursor to the [ONE TIME] item and
push the RTN button to switch to the data
input mode.
Select the [ACT] by scrolling the Push dial
and push the RTN button to set the ONE TIME
operation.
* When you want to reset ONE TIME operation, set the ACT/
INH item to [INH] and then reset it to [ON].
● ON/OFF direction
● Motor function switch
current position
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Start switch function
When active, the "START SW" allows the
motor's state to change from OFF to ON. The
motor is ON when the main SW and "START
SW" are turned ON simultaneously. The motor
changes to OFF only when the main SW is
turned off. If "START SW" is turned OFF but the
main SW is still ON, the motor remains ON.
[START SW function example]
When the throttle (motor) stick is assigned as the "START SW",
and the low throttle position of the throttle curve is adjusted, the
motor starts operating with the initial stick movement. The motor
will not cease functionality even if the stick position is returned to
its lowest setting.
●Trim effect / invalid setting in motor OFF
If one of the trim levers is assigned to the
Motor function, it is possible to turn the
motor off with the trim lever. To maintain
compatibility after updating the T12K, the
trim setting is adjusted to the on position.
However, it is suggested to return it to the off
position accordingly in the programming of
the transmitter.
*Data Reset will return the trim setting to the off position.
●Screen at the time of the motor OFF setting
When the MOTOR OFF setting is highlighted,
you will note the presence of the small cursor
that indicates the MOTOR OFF position. To
adjust this MOTOR OFF position, use the
throttle stick to move the cursor accordingly.
When satisfied with this position, push and
hold the RTN button on the transmitter.
*The larger cursor is used to indicate the output of the motor
channel. This cursor reflects any throttle curves and motor
mixing which may be active.
●Throttle curve button
When "CURVE" button is chosen, a throttle
curve screen opens.
*When a throttle function is assigned to either channel, the
"CURVE" button is not displayed because a throttle curve
does not function as a motor curve.
165