Table of Contents
Advertisement
Swash ring
This function limits the travel of the swash plate to
prevent linkage damage as the aileron and elevator
operation is used. It is useful for 3D heli setting.
●Tap the [Swash ring] button in the Linkage menu to
call the setup screen shown below.
●Return to
Linkage menu
The movement range
display shows control
input for elevator and
aileron direction.
The marker represents
the stick's position.
Swash ring setting procedure
1. Push the Swash ring button on the linkage
menu.
2. Push ACT/INH button to activate.
*The movement area monitor shows the current aileron and
elevator values and limit ranges by the yellow circle.
3. Adjust the rate to the maximum amount of
swash plate decline.
*The swash movement is limited within the circle.
Adjustment range: 50 - 200%.
Limits the swash travel within a fixed range to prevent linkage damage
(Helicopter only)
80
Setting the function to
"ACT" will display the
swash ring and [Rate]
percentage.
Advertisement
Table of Contents
