System Menu; Linkage Menu - FUTABA T16IZ Short Manual

The System menu sets up functions of the
transmitter. This does not set up any model data.
System menu functions table
Display
Sound volume
System timer
H/W setting
Battery
Range check
S.Bus servo
Information
The Linkage menu is made up of functions which
perform model addition, model type selection, end
point setting, and other model basic settings.
Linkage menu functions table
Servo monitor
Model select
Model type
Servo reverse
End point
Servo speed
Sub-trim
Function
Fail safe
System type
Trim setting
Throttle cut
Idle down
Swash ring
Swash
Stick alarm
Timer
Function name
Sensor
Telemetry
Tele.setting
Trainer
Warning setting
User menu setting
Date reset
36

SYSTEM MENU

Display adjustment.
Adjust the volume of: Other sound, Warning, Voice
Resets the system timer.
Stick mode selection (Mode 1 - Mode 4 ). J1-J4 sticks correction can be performed.
Battery alarm voltage setting. Auto power off time setting.
The output of the transmitter is lowered, for Range checking.
S.Bus servo setting.
Sets the User name, Language, and Unit system. Displays the program version, and micro SD card information.

LINKAGE MENU

Displays the servo test and operation position
Model addition, call, deletion, copy, model name setting
Model type, wing type, tail type, swash type, selection
Servo direction reversal
Servo basic rate adjustment and limit setting
Servo speed setting
Adjusts the neutral position of each servo
Channel assignment of each function can be changed
Fail safe function and battery fail safe function setting
System mode selection, link of a transmitter and receiver, telemetry mode selection
Control step amount and mode selection of the digital trim
Stops the engine safely and easily
Lowers the idle speed of the engine
Limits the swash plate travel to within a fixed range. (helicopter only)
Swash AFR and linkage correction function (helicopter only except swash type H-1)
Can be set so that an audible alarm sounds when the throttle stick reaches the set position.
Timer setting
Function name can be changed
Various telemetry sensors setting
Displays various data sent from the receiver
Telemetry data log
Starts and sets the trainer system.
Mixing, throttle position warning reset
Original menu making
Model memory set data reset (by item)
● When the System menu button is tapped,
the menu shown below is called up. Tap the
function button that you want to enter.