S.bus2 System - FUTABA FASSTest-2.4GHz T18SZ Series Instruction Manual

S.BUS2 System

When using the S.BUS2 port, an impressive array of telemetry sensors may be utilized.
Receiver port
S.BUS
S.BUS2
S.BUS servos and gyros and S.BUS2 servos and gyros must be used in the
correct receiver ports. Please refer to the instruction manual to make sure
you connect to the correct one.
S.BUS Servo
S.BUS2 servo
Connection is possible
S.BUS2 gyro
Connection is possible
Telemetry sensor
Connection is impossible
S.BUS2 TABLE
S.BUS Servo
S.BUS Gyro
○
× （※）
（※） Don't connect S.BUS Servo,
S.BUS Gyro to S.BUS2 connector.
CH Mode is set to ModeB [D].
Hub
Connection is impossible
S.BUS2
S.BUS2
○
○
Hub
Hub
S.BUS2 Servo
S.BUS servo
S.BUS2
Rudder Servo
Servo
Telemetry sensor
Gyro
S.BUS
Port
(8/SB)
S.BUS2
Port
Hub
Telemetry
Sensor
GYRO
＋
<Before Use>
×
○
35