Receiver Nomenclature - FUTABA T18MZ Instruction Manual

Receiver nomenclature

Before using the receiver, be sure to read the
precautions listed in the following pages.
Receiver R7008SB
Connector
"1 through 6": outputs for the channels 1 through 6
[S.BUS Sevo S.BUS Gyro ]
"S.BUS2": outputs of S.BUS2 port.
[Telemetry Sensor etc.]
*When using 9 or more channels,use an S.BUS
function. Or one more set R7008SB is purchased and
two sets of receivers are used by one set of a transmitter.
Connector insertion
Firmly insert the connector in the direction
90 degrees.
Warning
S.BUS2 connectors
connector.
LED Monitor
This monitor is used to check the CH mode of
the receiver.
Link/Mode Switch
It pushes with a plastic driver.
It is used for CH mode change.
(It is not used by a link.)
Extra Voltage Connector
When using this connector, Use this connector
when sending the voltage DC0
drive battery of a motor craft, etc. from the receiver
to the transmitter.
attached connector, and connect with Extra Voltage
connector.
Danger
* There is a danger of receiving an electric shock.
* A short circuit across the battery terminals may cause
and of wiring cannot be mistaken.
* If + and - of wiring are mistaken, it will damage, ignite and
explode.
turning on a receiver power supply.
70V of the
<Before Use> 25