Receiver Nomenclature - FUTABA 6K Instruction Manual

RECEIVER NOMENCLATURE

Before using the receiver, be sure to read the precautions listed in the following pages.
(Typical installation)
Mode Switch
Use the small plastic screw
driver that was included with your
receiver.
Switch is also used for the CH
mode selection. (CH6 ⇔ S.BUS)
Mode switch
LED
Antenna
R3006SB
LED Indication
Green Red
Off Solid No signal reception
Solid Off
Receiving signals
Alternate blink
Unrecoverable error (EEPROM, etc.)
DANGER
Don't connect a connector, as shown in a
before figure.
*It will short-circuit, if connected in this way. A short circuit
the battery terminals may cause abnormal heating, fire and
burns.
Don't connect servo for conventional system
to S.BUS2 port.
*Digital servo for conventional system→ It does not operate.
*Analog servo → It may cause abnormal heat, fire and burning.
WARNING
S.BUS2 connectors
Don't connect an S.BUS servo / gyro to
S.BUS2 connector.
S.BUS2 port
(SB2/B）
Status
1：Aileron servo
2：Elevator servo
3：Throttle servo (engine)
3：Motor controller (electric)
4：Rudder servo
5：Flap servo (airplane)
5：Gyro gain（Helicopter）
6：Aileron6 servo (airplane)
6：Pitch servo（Helicopter）
Switch
HUB
HUB
DANGER
Receiver
Do not insert either a switch
or battery in this manner.
Battery
Telemetry Sensor
Telemetry Sensor
Telemetry Sensor
37