YASKAWA SGD7S-***A20****F62 Series Product Manual page 55

3.2 Settings for Triggers at Preset Positions
3.2.3 Setting Trigger Outputs at Preset Positions with the SigmaWin+
3.
Click the High-Speed Output Settings Tab.
Information
4.
Set the items for the Output Setting 1 to 32 to use.
Refer to the following section for details on the settings of the items.
5.
After the settings are completed, click the All Parameters Button.
The edited data will be written to the volatile memory in the SERVOPACK.
6.
Click the Save to Flash Memory Button.
The edited data will be written to the non-volatile memory in the SERVOPACK.
Note: When you write edited data to the SERVOPACK, you must save it to flash memory. If the data is not
This concludes the procedure to set up triggers at preset positions.
3-10
If the Normal Output Settings Tab is clicked, the following dialog box will be displayed.
3.2.1 Setting Table Details on page 3-5
saved to flash memory, the edited data will be erased from memory when the power supply to the SER-
VOPACK is turned OFF.