Alarm Call - Technoalarm TP4-20 User Manual

To record the opening message press:
+ 1
The control panel emits two beep. After the beeps it is possible to start recording. Speak loud and clearly into the
microphone of the telephone (max. 10 seconds). On expiry of the recording time, the control panel emits 4 beeps.
WARNING
Recording of the opening message requires the master code.
+ #
to return to the main menu
PLAYING OF OPENING MESSAGE
To play the opening message press:
+ 2
The control panel plays the opening message.
Opening message
+ #
to return to the main menu
6.2

ALARM CALL

During an alarm call, it is possible to initiate the following functions:
Playing of opening message
Playing of alarm messages
Remote digital verification (RDV) through the active detectors (of the program in alarm)
On answering, the control panel reproduces the opening message of approximately 10 seconds, followed by the voice
message regarding the first alarm detected.
Opening message and first alarm
To pass on to the next alarm, press # (hash):
+ #
Once all the alarm messages have been played, if there are RDV detectors and if they are active, the remote digital
verification is activated automatically for approximately 20 seconds.
To close the communication and block the telephone channels press the key # (hash) again:
+ #
WARNING
The call takes about 60 seconds. If the communication is not shut down, the messages are repeated
until expiry of the call time.
6.3 SKIP ANSWERING MACHINE
If there are other devices connected to the telephone line the control panel is connected to (e.g. telefax, answering
machine) and they answer to incoming calls with a higher priority, i.e. after less rings, it is possible to skip them
programming 17 rings prior to answering and procede as follows:
Dial the number of the telephone line the control panel is connected to
After the first ring close the communication
Within one minute dial the same number again
The control panel receiving the second call within 6 and 60 seconds, answers immediately after the first ring (of the
second call) anticipating the other devices connected to the line.
WARNING
The control panels usually emit 1-second rings staggered with 4-seconds pauses. The standard
counting method is always active. From the second ring onwards the skip of the answering machine is
deactivated automatically. The function is reactivated after approximately 1 minute.
6-4 Control by Telephone User Manual - TP4-20