Technoalarm TP4-20 User Manual page 35

Codes 4
User codes
User codes 1
Code 01
Code 01 1
Code
Code 01
11111
Code 01 2
Acc. periods
Acc. periods
Period 01 [ # ]
Code 01 3
Programs
Programs
Program 01 [ # ]
Code 01 4
Attribute
TP4-20 - User Manual
3.1.7.2 STANDARD USER CODES
The control panel recognizes up to 20 standard user codes to be used for arming/
disarming or bypass of the programs associated.
The standard user codes have the same length as the master code and they can be
enabled for arming of the system using the programs analogously to the master code.
SELECTION OF THE CODE
+ wy
to select the code to be programmed (1 to 20)
+ #
to confirm the selection
In the standard user code menu the following parameters can be programmed:
Code (programming of the code)
Access periods (association of the access periods (de 1 a 8) during which the
selected code is enabled, i.e. recognized by the control panel)
Programs (association of the programs (1 to 32) the selected code is to act on)
Attribute (programming of the function of the code)
CODE
According to programming effected by the installer it is possible to program a code of
4, 5 or 6 digits.
Commands available
+ wy
to delete an existing code
+ 0...9
to program the standard user code
+ CL-EX
to confirm and quit
ACCESS PERIODS
The access periods (1 to 2) limit the period of recognition of the code selected by the
control panel. Outside the access periods associated, the entering of the code will
have no effect.
On the display is viewed current programming:
[ ] Access period not associated to the code selected
[ # ] Access period associated to the code selected
Commands available
+ wy
to select the access period
+ #
to associate the access period to the code selected
+ *
to undo the association
+ CL-EX
to confirm and quit
PROGRAMS
The association code-programs determines the programs (1 to 4) the code is to act
on, i.e. the programs it may arm/disarm or partset.
On the display is viewed current programming:
[ ] Program not associated to the code selected
[ # ] Program associated to the code selected
Commands available
+ wy
to select the program
+ #
to associate the program to the code selected
+ *
to undo the association
+ CL-EX
to confirm and quit
ATTRIBUTE
The following functions can be programmed:
Bypass (enables the code for the bypass of the programs associated)
Bypass general alarms (enables the code for arming of the system in presence of
general alarms, i.e. tamper, low battery, power failure, supervision, trouble
modules)
Hold-up (enables the code for the release of a silent alarm in case of hold-up
The hold-up alarm is released by entering a valid code reducing the last digit by
one, e.g. standard user code 11115, hold-up code 11114. If the code ends in 0
(e.g. 11110), the hold-up code ends in 9 (e.g. 11119))
Automatic abort on disarming (enables the code for the automatic block of the
alarm call cycles of all the active telephone channels and those waiting upon
disarming of the system)
Manual general abort (enables the code for the block of the alarm call cycles of
all the active telephone channels and those waiting entering the master code
again and pressing CL-EX on the console once the system has been disarmed)
Disabling remote arming/disarming by telephone (disables the code from arming/
disarming of the programs by telephone)
Disabling direct arming/disarming (disables the code from direct arming/
disarming, i.e. simultaneous arming/disarming of all the programs enabled for by
pressing # (hash))
Programming
3-9