Quick Disarming (If Enabled) - Technoalarm TP4-20 User Manual

WARNING
The hold-up alarm does not generate any signaling, neither by the control units nor by the sirens.
The event is stored in the event buffer of the control panel.
If the code ends in 0 (e.g. 43670), the hold-up code ends in 9, so 43679.
WARNING
Outside the access periods associated the codes are not accepted by the control panel and any
attempt at acceding to the system will have no effect.
When trying to do so, on the display is viewed ACCESS ! DENIED !.
Control by Console
4-10
and if programmed appropriately by the installer, the logic outputs OUT1 or OUT2 of
the CPU board and all the modules connected and a telephone call for hold-up alarm
are activated.
4.2.4

QUICK DISARMING (IF ENABLED)

It is possible to speed up the disarming process by pressing the key * (star) followed
by the program number, e.g.:
+ *1
+ *2
Repeat the command for all the programs to be disarmed.
4.2.5 DISARMING THROUGH KEY ZONE
The control panel can be disarmed through a contact connected to a zone
programmed by the installer as key zone.
Every time the contact is opened, all the programs that contain the key zone are
disarmed.
4.2.6 AUTOMATIC DISARMING
The control panel can be disarmed automatically using the 4 timers. Therefore, it is
possible to schedule the disarming of determined programs with a determined
frequency and at a determined time.
At the time programmed the timer disarms the programs associated.
4.2.7 DISARMING DURING THE ACCESS PERIODS
It is possible to define up to 2 access periods of the codes. As a consequence, the
codes are enabled for arming and disarming during the access periods associated by
the installer or the holder of the master code only.
User Manual - TP4-20