Special Operating Conditions - Technoalarm TP4-20 User Manual

WARNING
It is possible to use only one control unit at a time.
Control by Keypoint and Wireless Key
5-8
5.2.3.3 DEACTIVATION OF BYPASS WITH CODE
Enter a code enabled for bypass (master or standard user code enabled for the
programs armed) followed by the number of the program to be reactivated in its
integrity, e.g.:
+ 66778
+ 1
The led of the program previously partset becomes lit.
5.2.4

SPECIAL OPERATING CONDITIONS

5.2.4.1 FALSE CODE ALARM
The alarm is released if 32 keys are pressed without entering a valid code.
In case of false code alarm, the red LED 6 general alarm is blinking. The keypad on
which the false code has been entered is disabled for 2 minutes. Simultaneously, the
buzzers of the consoles connected are activated for 30 seconds and the OCG and
key leds of all the key readers and consoles are blinking.
To stop the alarm introduce a valid key or enter a valid code (master or standard user
code) on one of the other control units connected.
5.2.4.2 SIMULTANEOUS ARMING BY SEVERAL CONTROL UNITS
During the arming process by console, all the electronic keypads and key readers are
disabled.
In this situation, if you try to arm the control panel by electronic keypad, the 3 leds on
the keypad blink for approximately 3 seconds.
5.2.4.3 AUTOMATIC ABORT OF THE TELEPHONE CALLS
If enabled by the holder of the master code, on disarming of a program the active
telephone channels are blocked automatically.
5.2.4.4 GENERAL ALARM
If a general alarm is active (the corresponding LED is blinking), arming of the control
panel is not permitted with code unless the code is enabled for the bypass of the
general alarms.
User Manual - TP4-20