Technoalarm TP4-20 User Manual page 33

Call back 5
Call
Call
* NO # YES
Telephone 12
Mobile
Mobile 2
Answer [ ]
Mobile 4
Emergency no.
Emergency no.
011444555566666
Mobile 7
Enab.emer SMS[ ]
Prog.emer SMS
Waiting
TP4-20 - User Manual
3.1.6.4 DIRECT CALL BACK
The call back is a procedure designed to protect the installer as well as the owner of
the system against attempts at sabotage. If the installer (or monitoring station) calls
the control panel, after the first data exchange, the control panel interrupts the
communication and recalls the call back number programmed. Enabling this function,
the direct call back is enabled.
Commands available
+ #
to enable the call back
+ #
to disable the call back
+ CL-EX
to confirm and quit
3.1.6.5 PARAMETRIZACION TRANSMISOR TELEFONICO GSM
It is possible to program the following parameters:
Answering mode (enables answering to incoming calls)
Emergency number (called in case of interruption of the serial communication
between the control panel and the GSM telephone communicator)
Transmission of emergency SMS (enables the transmission of SMS in case of
interruption of the serial communication between the control panel and the GSM
telephone communicator)
(with TECNOCELL-PRO only)
Emergency SMS (sent in case of interruption of the serial communication
between the control panel and the GSM telephone communicator)
(with TECNOCELL-PRO only)
Commands available
+ wy
to select the parameter to be programmed
+ #
to confirm the selection
ANSWERING MODE
Permits enabling of the GSM telephone communicator for answering to incoming calls
transmitting one of the two system status messages (control panel in stand-by or
control panel in alarm). The GSM telephone communicator answers after
approximately 3 rings. The message is repeated until shutdown of the communication.
On the display is viewed current programming:
[ ] Answering mode disabled
[ # ] Answering mode enabled
Commands available
+ #
to enable el modo de respuesta
+ *
to disable el modo de respuesta
+ CL-EX
to confirm and quit
EMERGENCY NUMBER
If the communication between the control panel and the GSM telephone
communicator is interrupted for more than 30 seconds, the GSM telephone
communicator makes an emergency call towards the number programmed for this
(max. 15 digits).
Commands available
+ wy
to delete an existing number
+ 0...9
to program the telephone number
+ #*
to program the DTMF symbols # (hash) and * (star) inside the number
+ MEM
to program a pause
+ CL-EX
to confirm and quit
ENABLING OF THE EMERGENCY SMS
Permits to enable the transmission of an emergency SMS towards the emergency
number instead of a voice call in case of interruption of the communication between
the control panel and the GSM telephone communicator for more than 30 seconds.
On the display is viewed current programming:
[ ] Emergency SMS disabled
[ # ] Emergency SMS enabled
Commands available
+ #
to enable the transmission of the emergency SMS
+ *
to disable the transmission of the emergency SMS
+ CL-EX
to confirm and quit
EMERGENCY SMS
The SMS must be composed with the help of a mobile phone and sent to the number
corresponding to the SIM card of the GSM telephone communicator. Afterwards, te
SMS must be loaded onto the control panel.
Programming
3-7