Programming Of The Wireless Keys - Technoalarm TP4-20 User Manual

Key 01 5
Learning
Key 01
Learning [ # ]
Learning
Waiting
Learning
Completed
Menu 13
WL keys
WL keys 1
WL key 01
WL key 01 1
Acc. periods
Acc. periods
Period 01 [ # ]
TP4-20 - User Manual
Disabling exclusion (disables the key from the exclusion of zones (manually or
automatically) upon arming. In case of arming in presence of open zones, these
are activated and release the alarm.)
On the display is viewed current programming:
[ ] Function disabled
[ # ] Function enabled
Commands available
+ wy
to select the function
+ #
to enable the function
+ *
to disable the function
+ CL-EX
to confirm and quit
LEARNING
Before it is recognized by the control panel, the key must be learnt. This process
consists in storing the ID code of the device in the memory of the control panel.
On the display is viewed current programming:
[ ] Key not learnt (unknown)
[ # ] Key learnt (recognized)
Deletion of an existing key
Prior to learning of a new key, a possible existing one must be deleted by pressing:
+ # NO
to delete an existing key
LEARNING OF A NEW KEY
If the key selected has not yet been programmed (or the existing key has been
deleted), the control panel is waiting.
On the display is viewed Learning Waiting and the third led on the key reader
(yellow) is blinking.
Insert the key to be learnt into the key reader
The code of the key is stored in the memory of the control panel. Once the
process has been completed, on the display is viewed Learning Completed and
the led becomes lit.
Remove the key from the key reader
The led is switched off and the control panel returns to the key menu for
programming of further electronic keys.
3.1.9

PROGRAMMING OF THE WIRELESS KEYS

From the master programming menu select the submenu wireless keys.
The control panel recognizes up to 16 wireless keys to be used for total arming/
disarming, arming/disarming of the programs associated as well as activation/
deactivation of a remote control. Every wireless key provides 3 programmable
function keys.
SELECTION OF THE WIRELESS KEYS
+ wy
to select the wireless key to be programmed (1 to 16)
+ #
to confirm the selection
In the menu wireless keys the following parameters can be programmed:
Access periods (association of the access periods (1 to 2) during which the
wireless key selected is to be enabled, i.e. recognized by the control panel)
Association function keys (association of arming/disarming of the programs (1 to
4) or the activation/deactivation of the remote controls (1 to 2) to the 3 function
keys of the wireless keys)
Attribute (programming of the function of the wireless key)
Learning (storage of the code of the wireless key).
Commands available
+ wy
to select the parameter to be programmed
+ #
to confirm the selection
ACCESS PERIODS
The access periods (1 to 2) limit the period of recognition of the wireless key selected
by the control panel. Outside the access periods associated pressing of the function
keys of the wireless key will have no effect.
On the display is viewed current programming:
[ ] Access period not associated to the wireless key selected
[ # ] Access period associated to the wireless key selected
Commands available
+ wy
to select the access period
+ #
to associate the access period to the wireless key selected
+ *
to undo the association
+ CL-EX
to confirm and quit
Programming
3-11