Enabling Of The Consoles - Technoalarm TP4-20 User Manual

WL key 01 4
Learning
WL key 01
Learning [ ]
Learning
Waiting
Learning
Completed
Menu 15
Consoles
Consoles
Console 01 4 4 4 4 4
Menu 16
Exclusion
Exclusion 1
Zones
TP4-20 - User Manual
+ *
to disable the function
+ CL-EX
to confirm and quit
LEARNING
Before it is recognized by the control panel, the wireless key must be learnt. This
process consists in storing the ID code of the device in the memory of the control
panel.
On the display is viewed current programming:
[ ] Wireless key not learnt (unknown)
[ # ] Wireless key learnt (recognized)
Deletion of an existing key
Prior to learning of a new wireless key, a possible existing one must be deleted by
pressing:
+ # NO
to delete an existing wireless key
LEARNING OF A NEW KEY
If the wireless key selected has not yet been programmed (or the existing wireless key
has been deleted), the control panel is waiting.
On the display is viewed Learning Waiting.
Press the function key 1 for at least 10 seconds to initiate the process.
During this period of time, the device transmits its ID code to the control panel.
Once the process has been completed, on the display is viewed Learning
Completed.
The control panel returns to the wireless key menu for programming of further
wireless keys.
3.1.10

ENABLING OF THE CONSOLES

From the master programming menu select the submenu consoles.
The control panel provides up to 32 consoles.
SELECTION OF THE CONSOLE
+ wy
to select the console to be programmed (1 to 8)
+ #
to confirm the selection
If the console has been installed correctly and is ready to work, besides the name the
symbol 4 (tick) is viewed.
Every console can be programmed individually with the following parameters:
Quick arming (permits quick arming of the programs without code)
Quick disarming (permits quick disarming of the programs without code)
Panic (permits release of the panic alarm by pressing the arrow up/down key
simultaneously)
Quick menu (enables the console for the quick commands). It will then be
possible to activat/deactivate the remote controls without code.
On the display is viewed current programming:
[ ] Function not associated to the console selected
[ # ] Function associated to the console selected
Commands available
+ wy
to select the function
+ #
to enable the function
+ *
to disable the function
+ CL-EX
to confirm and quit
3.1.11 EXCLUSION OF MODULES
From the master programming menu select the submenu exclusion.
It is possible to volontarily exclude a device or a zone of the system (e.g. in case of
detector fault):
Zones (exclusion of the zones selected (1 to 20))
Wireless keys (exclusion of the wireless keys selected (1 to 16))
Consoles (exclusion of the consoles selected (1 to 8))
Keypoints (exclusion of the secondary control units selected (1 to 8))
Supervisory boards (exclusion of the supervisory boards selected (1 to 4))
GSM telephone communicator (exclusion of the telephone communicator with
GSM module)
Modules (exclusion of the external input extension module)
Wireless modules (exclusion of the wireless receiver selected (1 to 2))
Control panel (exclusion of the control panel)
SELECTION OF THE DEVICE
+ wy
to select the device/zone to be excluded
+ #
to confirm the selection
Programming
3-13