Technoalarm TP4-20 User Manual page 32

Telephone 1
Setting
Setting 1
Answer [ ]
Setting 11
Rings
Rings 11
17
Telephone 2
PABX
PABX
05
Telephone 3
Channel A
Channel A 1
First number
First number
011555666677777
Programming
3-6
3.1.6.1 GENERAL SETTINGS
It is possible to program the following parameters:
Answering mode (enables answering to incoming calls)
Number of rings prior to answering
Commands available
+ wy
to select the parameter to be programmed
+ #
to confirm the selection
ANSWERING MODE
Permits enabling of the control panel for answering to incoming calls. Enabling of the
answering mode is indispensable in order to give the installer access to the system for
remote programming or call back.
On the display is viewed current programming:
[ # ] Answering mode enabled
[ ] Answering mode disabled
Commands available
+ #
to enable the answering mode
+ *
to disable the answering mode
+ CL-EX
to confirm and quit
NUMBER OF RINGS PRIOR TO ANSWERING
The control panel can be programmed so as to answer to incoming calls after a
minimum of 3 and a maximum of 17 rings.
SKIP ANSWERING MACHINE
If the control panel is enabled for answering to incoming calls after 17 rings, it is
possible to accede to the system at distance without awaiting all the rings proceding in
the following way:
Call the control panel and replace the receiver after the first ring
Call the control panel again after 6 and within 60 seconds from the first call
If the control panel receives the second call within an intervall of 6 to 60 seconds from
the first one, interrupted after the first ring, it answers immediately.
Commands available
+ 0...9
to program the number of rings prior to answering
+ CL-EX
to confirm and quit
3.1.6.2 PABX
If the control panel is connected to a telephone line after a private automatic branch
exchange (PABX) switchboard, to capture the line it is necessary to dial a PABX
number of 1 to 16 digits.
Commands available
+ wy
to delete an existing number
+ 0...9
to program the PABX number
+ #*
to program the DTMF symbols # (hash) and * (star) inside the number
+ CL-EX
to confirm and quit
3.1.6.3 PARAMETERIZATION OF THE TELEPHONE CHANNELS (A...H)
The control panel supplies 8 independent telephone channels (A...H).
For every channel it is possible to program 2 telephone numbers, one principal that is
always called first and one reserve number that is only called if the line is busy or if
there is no answer. The control panel makes 4 attempts per channel alternating the
principal and the reserve number.
SELECTION OF THE CHANNEL
+ wy
to select the telephone channel to be programmed
+ #
to confirm the selection
The following parameters can be programmed:
Principal number (max. 15 digits)
Reserve number (max. 15 digits)
TELEPHONE NUMBERS
Select the telephone number to be programmed by pressing:
+ wy
to select the telephone number to be programmed
+ #
to confirm the selection
Commands available
+ wy
to delete the last digit
+ 0...9
to program the telephone number
+ #*
to program the DTMF symbols # (hash) and * (star) inside the number
+ MEM
to program a pause
+ CL-EX
to confirm and quit
User Manual - TP4-20