Error-Disable Recovery Configuration - ZyXEL Communications XMG1930 Series User Manual

Table 122 Advanced Application > Errdisable > Errdisable Detect (continued)
LABEL
Mode
Apply
Cancel

30.6 Error-Disable Recovery Configuration

Use this screen to configure the Switch to automatically undo an action after the error is gone. Click the
Click Here link next to Errdisable Recovery in the Advanced Application > Errdisable screen to display
the screen as shown.
Figure 174 Advanced Application > Errdisable > Errdisable Recovery
The following table describes the labels in this screen.
Table 123 Advanced Application > Errdisable > Errdisable Recovery
LABEL
Active
Reason
*
Timer Status
Chapter 30 Error-Disable
DESCRIPTION
Select the action that the Switch takes when the number of control packets exceed the rate
limit on a port, set in the Advanced Application > Errdisable > CPU protection screen.
• inactive-port – The Switch disables the port on which the control packets are received.
• inactive-reason – The Switch drops all the specified control packets (such as BPDU) on the
port.
• rate-limitation – The Switch drops the additional control packets the ports has to handle in
every one second.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select this option to turn on the error-disable recovery function on the Switch.
This field displays the supported features that allow the Switch to shut down a port or discard
packets on a port according to the feature requirements and what action you configure.
Use this row to make the setting the same for all entries. Use this row first and then make
adjustments to each entry if necessary.
Changes in this row are copied to all the entries as soon as you make them.
Select this check box to allow the Switch to wait for the specified time interval to activate a port
or allow specific packets on a port, after the error was gone. Clear the check box to turn off this
rule.
XMG1930 Series User's Guide
252