Table of Contents
Advertisement
Chapter 25
Remote Node Configuration
This chapter covers remote node configuration.
25.1 Remote Node Setup Overview
This section describes the protocol-independent parameters for a remote node. A
remote node is required for placing calls to a remote gateway. A remote node
represents both the remote gateway and the network behind it across a WAN
connection. When you use menu 4 to set up Internet access, you are configuring
one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then
edit that node's profile in menu 11.1, as well as configure specific settings in
three submenus: edit IP and bridge options in menu 11.3; edit ATM options in
menu 11.6; and edit filter sets in menu 11.5.
25.2 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
25.2.1
Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
Step 2.
From the main menu, enter 11 to display Menu 11 - Remote Node
Setup.
When menu 11 appears, as shown in the following figure, type the
number of the remote node that you want to configure.
Contivity 251 VPN Switch User's Guide
25-1
Advertisement
Table of Contents
