A.1.5 Communication Via Ethernet/Ip - Siemens SINAMICS Configuration Manual

Parameter
p2051[0...24]
r2053[0...24]
r2054
p8835
p8839[0...1]
p8840
r8850[0...19]
p8851[0...24]
r8853[0...24]
r8854
p8920[0...239]
p8921[0...3]
p8922[0...3]
p8923[0...3]
p8924
p8925
p8940[0...239]
p8941[0...3]
p8942[0...3]
p8943[0...3]
p8944
p8945
A.1.5 Communication via EtherNet/IP
A.1.5.1 Overview
EtherNet/IP is real-time Ethernet, and is mainly used in automation technology.
Communication via EtherNet/IP is possible via the following connections:
● Via the onboard interface X150
● Via the Option Board Ethernet CBE20
Possible drive units:
● CU320-2 PN
● CU320-2 DP
A.1.5.2 Connect drive device to Ethernet/IP
In order that your drive can be connected to a control system via Ethernet, your control system
requires a generic I/O module for cyclic communication via EtherNet/IP. You manually create
this generic I/O module in the control system.
Industrial Security
Configuration Manual, 08/2017, A5E36912609A
Description
CI: IF1 PROFIdrive PZD send word
IF1 PROFIdrive diagnostics PZD send word
PROFIBUS status
CBE20 firmware selection
PZD interface hardware assignment
COMM BOARD monitoring time
CO: IF2 PZD receive word
CI: IF2 PZD send word
IF2 diagnostics PZD send
COMM BOARD state
PN Name of Station
PN IP address
PN default gateway
PN Subnet Mask
PN DHCP mode
PN interfaces configuration
CBE2x Name of Station
CBE2x IP address
CBE2x Default Gateway
CBE2x Subnet Mask
CBE2x DHCP mode
CBE2x interfaces configuration
Communication
A.1 Communication
189