1.3.2
● When removing and installing the terminal cover with a screwdriver, be sure not to scratch your hand as
● Pressing too hard on the screwdriver may scratch the inverter.
1
● Always cut the power supply when removing the wiring cover.
Instruction
● After wiring is complete, be sure to replace the terminal cover.
Use the following procedure to remove both the upper and lower terminal block covers.
(1) Removing the lower (output and dc terminals) terminal block cover
1)
Insert a screwdriver or other thin object into the
hole indicated with the
3)
While pressing on the screwdriver, rotate the
terminal cover downward to remove it.
Opening the terminal cover
this results in injury.
mark.
Caution
2)
Press in on the screwdriver.
4)
Pull the terminal cover up at an angle.
A-6
E6581595